TZID/AZH POSITIONER
SPECIAL FEATURE
M - 12
Characteristic Curve
Use this function to create a user-defined characteristic curve by set-
ting input and output points.
Key Display Comments
Select CHARACTERIST. CURVE.
MODIFY and ERASE selections appear if a charac-
teristic curve is already defined in the device. The
characteristic curve is defined by 22 reference
points.
Point 1 and point 22 are fixed at 0 and 100%
respectively.
Enter an input point and press
. Enter an out-
put point.
Specify input and output values for points 2 through
21.
Each set of reference points must be greater than the
previous set of points.
Select YES to send the values to the positioner.
SPECIAL
FEATURE
DEVICE INFORMATION
CONTROL PARAMETERS
→CHARACTERIST. CURVE
OPERATING MODE
ENTER
CHARACTERIST. CURVE
NEW
→ MODIFY
ERASE
ENTER
POINT 1 INP (%)
nn.nn
POINT 1 OUT (%)
nn.nn
ENTER
POINT 2 INP (%)
nn.nn
POINT 2 OUT (%)
nn.nn
ENTER
ENTER
POINT 21 INP (%)
nn.nn
POINT 21 OUT (%)
nn.nn
ENTER
SEND CURVE VALUES?
NO
→ YES
To Next Page
Loading...
