ABB STT04 - Appendix I - XM;Sm;Xe Magnetic Flowmeter; Introduction; Create;Modify Configuration; Configuration Flowchart (XM;SM;XE Mag Flow

INTRODUCTION
I - 1
APPENDIX I - XM/SM/XE MAGNETIC FLOWMETER
INTRODUCTION
This appendix covers the configuration and calibration functions of
the XM/SM/XE Magnetic Flowmeter (Mag Flow).
Refer to OPERATING PROCEDURES in Section 4 for information on
the following functions:
NOTE: To change calibration or configuration parameters of a smart
field device that is connected to an IMFBS01 module, the device
must be taken off-line. This is done at the INFI 90 OPEN console.
CREATE/MODIFY CONFIGURATION
A configuration can be created off-line, without a connected field
device. Refer to Figure I-1 for an overview of the configuration func-
tion. The following table details the configuration process.
• Send configurations. • Select configurations.
• Get configurations. • Erase configurations.
• View configurations. • Operational functions.
Figure I-1. Configuration Flowchart (XM/SM/XE Mag Flow)
T01343A
SELECT
RESPONSE
TIME
ENTER
DAMPING
CONSTANT
ENTER LOW
FLOW CUTOFF
SAVE
CONFIGURATION
SELECT
ENGINEERING
UNITS
SELECT
DIGITAL FILTER
ID TAG
SELECT FAIL
MODE
SELECT RANGE
CONFIGURATION
SELECT MODE
SELECT
TOTALIZATION
UNITS
SELECT FLOW
DIRECTION
ENTER
CHANNEL
NUMBER
ENTER
DENSITY
FACTO R
DIGITAL
ANALOG
NO
YES
SELECT
DEVICE
TYPE
ENTER PULSE
FACTO R
SELECT EMPTY
PIPE DETECTOR
SELECT FLOW
DIRECTION
ENTER PULSE
WIDTH
ENTER UPPER
AND LOWER PV
ALARMS
C
O
N
F
I
G
U
R
E
UNIT MASS
RELATED?
ENTER RANGE
VALUES
ENTER UNIT
DESCRIPTOR
ENTER UNIT
FACTO R
USER-DEFINED
ENTER TIME
RELATION