ABB STT04 - Page 137

BCN PRESSURE TRANSMITTER
CREATE/MODIFY CONFIGURATION
G - 4
Input lower range value using the number keys and
press . Input the upper range value. The
UNITS displayed will be those designated in the pre-
vious screen.
Select LOW using the arrow keys.
Refer to the Smart Pressure Transmitter BCN
instruction for mode description.
Select LOW using the arrow keys.
This is a 6 character alphanumeric designation to
represent values in user familiar units.
To select a character, press the key that has the
desired character. Continue to press the key until the
desired character appears. Use the right arrow key to
move to the next character. Use the left arrow key to
go back to the previous character. Press
when finished.
Specify secondary values using the number keys.
The UNITS displayed will be those designated in the
previous screen. After entering a value press
.
Make a selection using the arrow keys.
The Configuration ID tag name just configured will be
in the upper left corner if the configuration is saved. It
becomes the working configuration.
Key Display Comments
ENTER
LOWER RANGE VAL.
nn.nn UNITS
UPPER RANGE VAL.
nn.nn UNITS
ENTER
ENTER
INITIALIZE MODE:
→ LOW
HIGH
ENTER
FAIL MODE
→ LOW
HIGH
LAST
ENTER
ENTER
SECONDARY UNITS
_nnnnnn
ENTER
ENTER
SECONDARY L. R.
nn.nn UNITS
SECONDARY U. R.
nn.nn UNITS
ENTER
ENTER
STORE THIS
CONFIGURATION?
NO
→ YES
ENTER
ID TAGNAME
READY