ABB STT04 - Page 4

ADDENDUM
2
Table 1 provides a comparison of old-ke
y
pad vs. new-ke
y
pad functions for the ke
y
s on the STT04 terminal.
NOTE: The configure, view, select device and options keys function without a field device connected to the
STT04 terminal. The other functions are locked out until a field device is connected to the terminal.
Table 1. Keypad Functions
Old Key New Key Function
Powers the unit up and displa
y
s the
STT04
firmware revision level.
Turns power off. Stored confi
g
urations remain in internal memor
y
. The termi-
nal will shut itself off after 15 minutes of idle operation.
Scrolls throu
g
h menus and selects functions.
Inputs values into the terminal. Includes di
g
its 0 throu
g
h 9, ASCII characters A
throu
g
h Z, si
g
ns, and punctuation.
Completes an input or a selection.
1. Inputs a new confi
g
uration into the
STT04
internal memor
y
.
2. Modifies an existin
g
confi
g
uration.
3. Erases an existin
g
confi
g
uration from the terminal memor
y
.
Retrieves, views and optionall
y
saves the confi
g
uration of the selected field
device.
Sends a confi
g
uration from the STT04 terminal to a selected field device.
Steps throu
g
h various calibration procedures
(
dependent on the selected field
device
)
.
Monitors primar
y
input or output, secondar
y
output, ambient temperature of
the selected field device, and other variables.
ON
OFF
+ : /
< > *
0
% &
G H I
9
ENTER
CONFIG
GET
CONFIG
SEND
CONFIG
CALI-
BRATE
MONITOR