11-15
Questions? Refer to Page 11-22 For Technical Support Instructions.
Chapter 11: Troubleshooting
Symptom/Error Message Explanation How To Respond
The ID or lot number just scanned or
entered is too long or too short, according
to format defined during the setup of this
meter.
1. Verify and re-enter the ID or lot number
using the barcode scanner or keypad.
2. If the problem persists, notify the system
administrator.
The ID or lot number just scanned or
entered is not on the list of acceptable IDs
or lot numbers defined for this meter. (The
menu item 2 – Continue appears only if
this option is set to Warn.)
1. Press 1 to ReEnter the ID or lot number
using the barcode scanner or keypad.
Or,
Press 2 to Continue testing.
2. If the problem persists, notify the system
administrator.
To Next Page
Loading...
