4-9
Questions? Refer to Page 11-22 For Technical Support Instructions.
Chapter 4: Control Test
What You See on the Display What You Do Comments
9. Wait for the meter to analyse the sample
and display the test result.
When using FreeStyle Precision Pro
test strips the countdown will begin at 5
seconds. When using Precision Xceed
Pro test strips the countdown will begin
at 20 seconds.
The meter counts down then displays the
test result. If an error is detected during
the assay, the assay is terminated and no
result is displayed. Once the assay begins,
all key presses are ignored until the assay is
completed.
92 mg/dL
10. Note the test result and whether it falls
within the acceptable range.
If required, scan or manually enter the
comment code and press Enter.
If there is no prompt to enter a
comment code skip down to step 11.
Control test results can appear as numeric
or PASS/FAIL, depending on how the test
is set up. If numeric, an “X” will appear in
front of a test result that is out-of-range.
The meter may be enabled to scan or enter a
1- to 2-digit comment code.
To Next Page
Loading...
