EasyManuals Logo

Abbott i-STAT 1 System Manual

Abbott i-STAT 1
658 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
Art: 728690-00D Rev. Date: 02-Aug-12
12
17. If additional DRCs require configuration, connect the next DRC to the PC per step 2 and apply
power to the DRC and repeat steps 9 through 16. Otherwise, proceed to step 18.
RESTORING THE PC’S NETWORK CONFIGURATION:
18. Disconnect the Ethernet cable from the DRC and the PC. On the PC, click StartSettings
Control PanelNetwork and Internet Connections (if listed)Network Connections.
19. Right-click on “Local Area Connection” and select Properties.
20. Select the “Internet Protocol (TCP/IP) connection and click the Properties button.
21. Restore Internet Protocol (TCP/IP) Properties in the General tab to the network settings recorded
in Step 6.
22. Click OK and close all Control Panel windows.
23. Connect the network cable from the PC to the network (wall).
24. To connect the configured DRC for transmissions to the Data Manager, following the instructions
in the Wiring the Downloader/Recharger sections below.

Table of Contents

Other manuals for Abbott i-STAT 1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Abbott i-STAT 1 and is the answer not in the manual?

Abbott i-STAT 1 Specifications

General IconGeneral
BrandAbbott
Modeli-STAT 1
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals