3-24 Machine Maintenance Procedures
3. Carefully flip keyboard as shown in Figure 3-20.
Figure 3-20. Keyboard FPC
4. Remove keyboard FPC (B) from mainboard connector (A).
Keyboard Installation 0
1. Insert keyboard frame flanges (A, Figure 3-21) into upper cover slots.
Figure 3-21. Keyboard Frame Flanges
2. Flip keyboard frame over until keyboard FPC (B) can be connected to mainboard
connector (A) (Figure 3-20).
3. Place keyboard frame flush against the upper cover. Refer to Figure 3-19.
4. Secure the six latches.
5. Install battery pack.
SG_JE50_HR.book Page 24 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
