Machine Maintenance Procedures 3-33
Bluetooth Module Removal 0
Prerequisite:
Upper Cover Removal
1. Locate Bluetooth module (B) on upper cover. Refer to Figure 3-29.
2. Remove module (A) from adhesive strip on upper cover (Figure 3-32).
Figure 3-32. Bluetooth Module
3. Disconnect module cable (B) from module (A).
Bluetooth Module Installation 0
1. Connect module cable (B) to module (A) (Figure 3-32).
2. Install and secure module (A) to adhesive strip on upper cover.
3. Install upper cover.
SG_JE50_HR.book Page 33 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
