Machine Maintenance Procedures 3-49
DC-IN Cable Removal 0
Prerequisite:
LCD (Liquid Crystal Display) Module Removal
1. Locate DC-IN cable (A) on mainboard (Figure 3-49).
Figure 3-49. DC-IN Cable Removal
2. Remove cable from guides on lower cover.
3. Remove cable connector from lower cover.
DC-IN Cable Installation 0
1. Install cable connector to lower cover (Figure 3-49).
2. Install cable in cable guides on lower cover.
3. Install LCD module.
SG_JE50_HR.book Page 49 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
