Acer Aspire 5750, 5750G - LCD Panel Removal; LCD Panel Installation

Machine Maintenance Procedures 3-53
LCD Panel Removal 0
Prerequisite:
CCD (Charge-Coupled Device) Module Removal
1. Locate LCD panel (B) on module cover. Refer to Figure 3-53.
2. Remove four (4) screws (C) from module cover.
3. Lift adhesive foil tabs (D) covering LVDS cable (E).
4. Remove panel from module cover.
5. Turn panel over and place face down on a clean surface (Figure 3-55).
Figure 3-55. LCD Panel
6. Remove CCD module cable (A) from panel.
7. Pull back transparent adhesive protector (B) securing LVDS cable (D) to panel.
8. Remove LVDS cable (D) from panel connector (C).
LCD Panel Installation 0
1. Install LVDS cable (D) to panel connector (C) (Figure 3-55).
2. Secure transparent adhesive protector (B) to LVDS cable (D) and panel.
3. Install and secure CCD module cable (A) to panel.
4. Place LCD panel onto module cover. Refer to Figure 3-53.
5. Secure adhesive foil tabs (D) covering LVDS cable (E) to module cover.
6. Install and secure four (4) screws (C) to module cover.
7. Install CCD module.
Size Quantity Screw Type
M2.5x4.0 4
A
B
C
D
SG_JE50_HR.book Page 53 Thursday, December 23, 2010 3:47 PM