System Utilities 2-21
Using Boot Manager 0
The Boot Manager allows the boot device to be changed without accessing the BIOS.
The F12 Boot Menu option must be set to Enabled in the BIOS Setup Utility’s Main
screen. (refer to Main)
To use the Boot Manager, perform the following steps:
1. Start the computer.
2. When prompted, press F12 during POST procedure. The Boot Manager dialog is shown.
(Figure 2-24)
Figure 2-24. Boot Manager Dialog
3. Use the and keys to highlight the boot device.
4. Press Enter to select an option an continue the boot procedure.
SG_JE50_HR.book Page 21 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
