Acer Aspire 5750, 5750G - Changing a Password

2-10 System Utilities
Set Supervisor Password dialog box appears:
Figure 2-5. Set Supervisor Password
2. Type current password in Enter Current Password field and press Enter.
3. Press Enter twice
without typing anything in Enter New Password and Confirm New
Password fields. Computer will set Supervisor Password parameter to Clear.
4. Press F10 to save changes and exit the BIOS Setup Utility.
Changing a Password 0
1. Use the  and keys to highlight Set Supervisor Password and press Enter. The
Set Supervisor Password dialog box appears.
Figure 2-6. Set Supervisor Password
2. Type current password in Enter Current Password field and press Enter.
3. Type new password in Enter New Password field. Retype new password in Confirm
New Password field.
4. Press Enter. Computer sets Supervisor Password parameter to Set.
NOTE:
NOTE:
Password on Boot must be set to Enabled to activate the password
feature.
5. Press F10 to save changes and exit BIOS Setup Utility.
If the verification is OK, the screen shows as follows.
SG_JE50_HR.book Page 10 Thursday, December 23, 2010 3:47 PM