Machine Maintenance Procedures 3-57
Microphone Module Removal 0
Prerequisite:
LCD Panel Removal
1. Locate module (D) on LCD module cover. Refer to Figure 3-57.
2. Lift foil tabs (A) covering module cable (B).
Figure 3-59. Microphone Module and Cable
3. Lift foil tab covering module.
4. Remove module (C) and cable (B) from LCD module cover.
Microphone Module Installation 0
1. Install module (C) and module cable (B) on LCD module cover (Figure 3-59).
2. Secure foil tab covering module (C) to LCD module cover.
3. Secure foil tabs (A) covering module cable (B) to LCD module cover.
4. Install LCD panel.
SG_JE50_HR.book Page 57 Thursday, December 23, 2010 3:47 PM