3-40 Machine Maintenance Procedures
Thermal Module Installation 0
Apply suitable thermal grease and make sure all heat pads are in place before
replacing module
.
Thermal grease can damage mainboard. Use caution when applying.
The following thermal grease types are approved for use:
N302
1. Remove all traces of thermal grease from CPU using a lint-free cloth or cotton swab and
Isopropyl Alcohol, Acetone, or other approved cleaning agent.
2. Apply small amount of thermal grease to center of CPU (A) (Figure 3-39).
Force used during installation of thermal module is sufficient to spread grease over
CPU top.
Figure 3-39. Applying Grease to CPU
SG_JE50_HR.book Page 40 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
