Machine Maintenance Procedures 3-41
3. Align module and heatsink to mainboard screw holes (Figure 3-40).
Keep module level to spread grease evenly.
Figure 3-40. Thermal Module Installation
4. Install and secure four (4) screws (C/1 - C/4) and two (2) screws (D/5 - D/6), in numerical
order from one (1) to six (6), to mainboard. Refer to Figure 3-38.
5. Install module cable (B) to mainboard connector.
6. Install mainboard.
Size Quantity Screw Type
M2.3x3.2 Ni 4
M2.5x4.0 Ni 2
SG_JE50_HR.book Page 41 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
