3-14 Machine Maintenance Procedures
Base Door Removal 0
Prerequisite:
Battery Pack Removal
1. Locate base door (C) on lower cover. Refer to Figure 3-6.
2. Remove two (2) screws (A) as shown in Figure 3-10.
Figure 3-10. Lower Cover Door Screws
3. Remove door from lower cover.
Base Door Installation 0
1. Insert door flanges (A, Figure 3-11) into slots on lower cover.
Figure 3-11. Base Door Flanges
2. Secure door to lower cover with two (2) screws (A) (Figure 3-10).
3. Install battery pack.
SG_JE50_HR.book Page 14 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
