Machine Maintenance Procedures 3-47
5. Flip computer over to show mainboard. Refer to Figure 3-35.
6. Remove adhesive tape securing WLAN cable (B) to mainboard and lower cover.
7. Pull WLAN and 3G antenna cables up through upper cover.
8. Remove four (4) screws from LCD module hinges (Figure 3-47).
Figure 3-47. LCD Module Hinge Screws
9. Remove LCD module from lower cover.
Figure 3-48. Removing LCD Module
LCD Module Installation 0
1. Install LCD module on lower cover (Figure 3-48).
2. Install and secure four (4) screws (A) to lower cover. Refer to Figure 3-47.
3. Put WLAN antenna cables down through mainboard and lower cover. Refer to
Figure 3-35.
4. Install and secure WLAN cables (B) to mainboard and lower cover with adhesive tape.
5. Put 3G antenna cables (G) through lower cover. Refer to Figure 3-29.
6. Flip computer over to see lower cover.
7. Connect 3G antenna cables (A) to 3G module connectors. Refer to Figure 3-46.
8. Install WLAN antenna cables (A) to guides (B) on lower cover. Refer to Figure 3-45.
SG_JE50_HR.book Page 47 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
