3-22 Machine Maintenance Procedures
DIMM (Dual In-line Memory Module) Module Removal 0
Prerequisite:
Base Door Removal
1. Locate module (C) on lower cover. Refer to Figure 3-12.
2. Push module clips (A) outwards. (Figure 3-18)
Figure 3-18. DIMM Module(s)
3. Disconnect module from mainboard connector (B).
4. Repeat steps 2 and 3 for remaining modules.
DIMM Module Installation 0
1. Connect module to mainboard connector (B) (Figure 3-18).
2. Push down on module until clips (A) lock in place.
3. Repeat steps 2 and 3 for remaining modules.
4. Install base door.
SG_JE50_HR.book Page 22 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
