Machine Maintenance Procedures 3-35
Speaker Module Removal 0
Prerequisite:
Upper Cover Removal
1. Locate speaker modules (D) on upper cover. Refer to Figure 3-29.
2. Remove two (2) screws (A) (Figure 3-34).
Figure 3-34. Speakers
3. Remove speaker cable (C) from mainboard connector (B).
4. Remove speaker modules.
Speaker Module Installation 0
1. Install speaker modules on lower cover (Figure 3-34).
2. Install speaker cable (C) to mainboard connector (B).
3. Install and secure two (2) screws to lower cover.
4. Install upper cover.
SG_JE50_HR.book Page 35 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
