Machine Maintenance Procedures 3-51
3. Starting from the bottom-center of the bezel (Figure 3-52), pry the bezel upwards and
away from the panel. Move along the edge until the bezel is completely removed.
Figure 3-52. LCD Bezel Removal
LCD Bezel Installation 0
1. Locate the bezel hinges (B) on LCD cover (Figure 3-52).
2. Press down until there are no gaps between the bezel and the LCD module cover hinge
wells.
Make sure that the LCD cables pass through the hinge wells and are not trapped by the
bezel.
3. Press the entire perimeter of the bezel until there are no gaps between the bezel and the
LCD module.
4. Install the two (2) screws (B) and mylar covers to secure the LCD bezel. Refer to
Figure 3-50.
5. Install LCD Module.
Size Quantity Screw Type
M2.5x4.0 2
SG_JE50_HR.book Page 51 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
