3-18 Machine Maintenance Procedures
HDD Carrier Removal 0
Prerequisite:
HDD (Hard Disk Drive) Module Removal
1. Remove four (4) screws (A) from the brackets (Figure 3-14).
Figure 3-14. HDD Module Brackets
2. Remove brackets (B) and (C) and mylar (D) from HDD.
3. Remove mylar from brackets.
HDD Carrier Installation 0
1. Install mylar (D) to brackets (C) and (D) (Figure 3-14).
2. Install and secure brackets and mylar to HDD module with four (4) screws (A). (Figure
3-14)
3. Install HDD module.
Size Quantity Screw Type
M3.0x3.0Ni 4
SG_JE50_HR.book Page 18 Thursday, December 23, 2010 3:47 PM