Machine Maintenance Procedures 3-11
3G Card Removal 0
Prerequisite:
Battery Pack Removal
1. Locate 3G card slot (A) in battery bay (Figure 3-6).
Figure 3-6. Lower Cover Overview with Base Door
2. Push 3G card (B) in to release it from spring latch (Figure 3-7).
Figure 3-7. 3G Card
3. Remove 3G card (B).
3G Card Installation 0
1. Insert 3G card (A) into 3G card slot (Figure 3-7).
2. Push card until spring latch locks.
3. Install battery pack.
SG_JE50_HR.book Page 11 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
