3-32 Machine Maintenance Procedures
3. Disconnect module FFC (FPC, Figure 3-31) (A) from module connector (B).
Figure 3-31. USB 3.0 Module
USB 3.0 is an optional feature and may not represent the final product.
4. Disconnect module FFC (FPC, Figure 3-31) (A) from mainboard connector (C).
5. Remove module from lower cover.
USB Module Installation 0
1. Install module (C) on lower cover. Refer to Figure 3-29.
2. Install module FFC (FPC, Figure 3-31) (A) to mainboard connector (C). Refer to
Figure 3-30.
3. Install module FFC (FPC, Figure 3-31) (A) to module connector (B).
4. Install and secure screw (D) to lower cover.
5. Install upper cover.
SG_JE50_HR.book Page 32 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
