System Utilities 2-15
DOS Flash Utility 0
Perform the following to use the DOS Flash Utility:
1. Press F2 during boot to enter Setup Menu.
2. Select Boot Menu to modify boot priority order.
3. Move USB HDD to position 1. (Refer to Boot menu)
Figure 2-12. Changing BIOS Boot Priority Order
4. Copy FLASH.BAT to USB HDD.
5. Insert USB HDD and reboot computer.
6. Execute FLASH.BAT to update BIOS. Flash process begins as shown in Figure 2-14.
Figure 2-13. Executing FLASH.BAT
InsydeH20 Setup Utility Rev. 3.5
Information Main Security Boot Exit
Item Specific Help
Boot priority order:
USe <> or <> to
select a device, then
press <F5> to move it
down the list, or <F6>
to move it up the list.
Press <Esc> to escape
the menu.
1. HDD: WDC WD 2500BPVT-22ZEST0
2. ATAPI CDROM: MATSHITADVD-RAM UJ890AS
3. USB FDD:
4. Network Boot: LEGACY PCI DEVICE
5. USB HDD: xxxx USB
6. USB CDROM:
F1 Help Select Item F5/F6 Change Values F9 Setup Default
ESC Exit Select Menu Enter Select>SubMenu F10 Save and Exit
SG_JE50_HR.book Page 15 Thursday, December 23, 2010 3:47 PM
To Next Page
Loading...
