Machine Maintenance Procedures 3-45
4. Lift right side (E) of mainboard until edge is a few cm above lower cover as shown in
Figure 3-48.
Figure 3-48. Freeing Mainboard Connectors
Connectors on left side of mainboard are set in lower cover slots. Do not force
mainboard when removing.
5. Release mainboard from lower cover.
DC-IN cable is connected to the mainboard. Do not pull mainboard away from
lower cover.
6. Flip mainboard to expose DC-IN connector on mainboard (Figure 3-49).
Figure 3-49. Mainboard DC-IN Connector
7. Disconnect DC-IN cable (C) from mainboard connector (D).
8. Remove mainboard from lower cover.
SG_JV51_HR.book Page 45 Friday, July 8, 2011 5:58 PM
To Next Page
Loading...
