Jumper and Connector Locations 5-15
6. Press the Power button to initiate system CRISIS mode (Figure 5-17).
Figure 5-17. Pressing the Power Button
If the CRISIS mode did not initiate correctly, make sure the file name is correct on the
USB HDD. Disconnect the AC adapter and battery to reset the embedded status.
Repeat steps 1 through 6.
7. When CRISIS procedure is complete, the system auto restarts with a workable BIOS.
SG_JV51_HR.book Page 15 Friday, July 8, 2011 5:58 PM
To Next Page
Loading...
