108 Accessories and options
fabian HFO | SW 5.1.x
Ref: 113003.EN / Date 2020-02-10
12.2.2.2 Connect to fabian HFO with Main Board 2.x
To connect any of the compatible CO
2
module to the fabian HFO with Main Board 2.x (Figure
10),
1. Attach the 9-pin RS-232 Connector from the CO2 module (Figure 11) to the Receptacle RS-232
Connector at the back of the fabian HFO labelled with Data input / output symbol (Figure 12).
2. Fasten the connection by turning the screws on either side of the pinned connector clockwise.
Figure 10 - Rear View of fabian HFO (Main Board 2.x). Arrow points towards CO
2
port.
To Next Page
Loading...
