aditec MIC 3000 - Page 7

User Manual MIC 900 / MIC 1100 / MIC 3000
7
Issue 17.08.2021_00
MIC 900, MIC 1100 and MIC 3000
Only
MIC 900 +
MIC 3000
Pause
Pausing program runs and resuming a paused program
run.
LED flashes – program in hold mode/start time runs
Start / Stop
Starting and stopping programs.
LED lights – control in operation
LED flashes – end of the program
Cursor left -
Moving horizontally to the next operating element on the
left.
Cursor right +
Moving horizontally to the next operating element on the
right.
Cursor up
Moving vertically up to the next operating element.
Entering number values (incremented).
Cursor down
Moving vertically down to the next operating element.
Entering number values (decremented).
Cursor ENTER
Confirm the selected button/box
Only MIC 1100 + MIC 3000
Control buttons 1-5
Depending on the page that is currently displayed, the
functions of the buttons change. The current
function/description of the button corresponds to the
buttons on the task bar.
On the menu display you can see the following
descriptions:
F1 – Configuration
F2 – Service
F3 – Start page
F4 – Profiles
F5 – Programs
Chamber
temperature
Short-cut button for entering nominal chamber
temperature value (min, max)
LED shines – heating is active
Step time
Short-cut button for entering the nominal step time
LED shines – control in operation
Repetition
The function button can be allocated freely (in
preparation)
(only MIC 3000)
Humidity max
Short-cut button for entering the nominal humidity value
max
LED shines – dehumidification is active
Core temperature
Short-cut button for entering the nominal core
temperature value
LED shines – cooling is active