ADTRAN MX2800 - Page 138

Index
Index-8 MX2800 User Manual 61200290L1-1
Subnet Mask menu
3-13
Supply Failure, System State Alarm
4-5
switch cards, forcing the controller to
3-5
Switched, System State Alarm
4-5
Syslog Setup menu
3-26
system alarms
3-17
System Management menus
3-12
system reset
3-29
System Security menu
3-24
System State Alarm
Card Failure
4-5
Excessive Switches
4-5
Supply Failure
4-5
Switched
4-5
System State menu
4-5
T
T1/E1 Alarm Traps 3-23
CAIS
3-23
DS1 Eqpt Fail NSA
3-23
DS1 Eqpt Fail SA
3-23
In/Out Test
3-23
LAIS
3-23
LOS
3-23
Multiple DS1 LOS
3-23
Single DS1 LOS
3-23
T1/E1 Failure
3-23
XCV
3-23
T1/E1 Alarms
3-18
T1/E1 Failure
3-23
T1/E1 Line Length menu
3-9
T1/E1 menus
Circuit Protection
3-10
Interface
3-6
Line Coding
3-8
Line Identification
3-11
Loopback Detection
3-9
State
3-7
T1/E1 State
CAIS
4-8
HOT
4-8
LAIS
4-8
LOS
4-8
OK
4-8
TST
4-8
XCV
4-8
T1/E1 State menu
4-8
T1/E1 Statistics menu
5-10
T1/E1 Status LEDs
2-15
Telnet, overview
1-4
Temp Critical, Power Supply State
4-4
Temp High, Power Supply State
4-4
Temperature Critical, Power Supply Alarm
3-18
Temperature Critical, Power Supply Alarm Traps
3-20
Temperature High, Power Supply Alarm
3-18
Temperature High, Power Supply Alarm Traps
3-
20
terminal connection, establishing
2-10
TFTP updates
3-29
time, setting
3-25
Timing menu
3-4
TLOS, State
4-3
Transmission menu
3-26
Trap Community Name menu
3-24
Trap Generation menu
3-19
Trap IP Addresses menu
3-19
traps
controller
3-19
for calls between primary and secondary
numbers
3-14
for redialing
3-14
Tributary loopback
6-2
TST, T1/E1 State
4-8
TX LOS
3-21
U
UL information (DC version) 2-4
Unavailable Seconds (UAS)
5-4
Unit ID Code menu
3-26
Unknown, Remote state
4-4
unpacking the unit
2-1
updating software
3-29
via TFTP
3-29
via xmodem
3-29
Utilities menu
3-28
V
viewing statistical information 5-1
viewing statistical information, display options for
5-1
viewing system information
3-28
W
Write Community Name 3-24