Chapter 3. Configuration
3-26 MX2800 User Manual 61200290L1-1
Unit ID
Provides a user-configurable text string for the name of the
MX2800. This name can help you distinguish between different
installations. You can enter up to 32 alpha-numeric characters in
this field, including spaces and special characters (such as an
underbar). This information is locally stored and displayed in the
upper right-hand corner of the MX2800 terminal screens (see Figure
3-16).
Facility ID/Location ID/Frame ID/Unit and Equipment Codes
These fields provide user-configurable text strings to identify the
MX2800 over the network. The
L
OCATION
ID C
ODE
,
F
RAME
ID C
ODE
,
and
E
QUIPMENT
C
ODE
fields support up to ten alpha-numeric char-
acters each. The
F
ACILITY
ID C
ODE
supports 38 characters and the
U
NIT
C
ODE
supports 6 characters. This information is transmitted
over the DS3 on the equipment ID channel.
Syslog Setup
Selections include
T
RANSMISSION
,
H
OST
IP A
DDRESS
,
S
EVERITY
L
EVEL
, and
H
OST
F
ACILITY
.
Transmission
Enables or disables the transmission of log events to the external
Syslog server. You must first define the host IP address.
Host IP Address
Specifies the IP address of the external server that is running the
Syslog host daemon.
Severity Level
Specifies the lowest level of severity that causes messages to be
logged to the Syslog server. The levels are listed in Table 3-1 on
page 3-27, in order of decreasing severity. Any message at or above
a selected severity level will be logged if a transmission is enabled.
To Next Page
Loading...
