Total Access
®
3000/3010 System Manual
6TADLP744-1E
TOTAL ACCESS 3000/3010
DLP-744
Page 11 of 12
© 2003, ADTRAN, Inc.
Perform Steps Below in the Order Listed
Provision SCU on Expansion (Client) shelf
SCU/Provisioning/General/Management Ports/Interbank Comm.
Mode – Client
SCU/Provisioning/TL1/Client Shelf Management – Expansion Shelf
Automatic connection to Unit Number – 2 (for Expansion Shelf #1) or 3 (for
Expansion Shelf #2)
Verify Target ID is same as what was entered in the Host SCU
Repeat procedure for Expansion Shelf #1 and #2
Provision OC-3 L2 MUX
OC-3 MUX/Provisioning/OC-3 Provisioning/OC-3 Transmission Sync
Message – Derive From Source
OC-3 MUX/Provisioning/EC1 #1 Provisioning/ Transmission Sync Message –
Derive From Source
OC-3 MUX/Provisioning/EC1 #2 Provisioning/ Transmission Sync Message –
Derive From Source
OC-3 MUX/Provisioning/MUX Provisioning/Linked Provisioning – Enabled
(for redundant MUX operation)
OC-3 MUX/Provisioning/MUX Provisioning/Clock Source – Receive OC-3
from both A and B Fibers
OC-3 MUX/Provisioning/MUX Provisioning/DCC Options/OC-3 DCC/DCC
Mode – User
OC-3 MUX/Provisioning/MUX Provisioning/DCC Options/EC1 #1 DCC/
DCC Mode – Disabled
OC-3 MUX/Provisioning/MUX Provisioning/DCC Options/EC1 #2 DCC/
DCC Mode – Disabled
OC-3 MUX/Provisioning/MUX Provisioning/DCC Options/System ID – per
Network Administrator
OC-3 MUX/Provisioning/MUX Provisioning/DCC Options/NSAP Area
Address – per Network Administrator
OC-3 MUX/Provisioning/MUX Provisioning/DCC Options/Terminal ID –
verify that it matches the Target ID on the SCU
OC-3 MUX/STS-1 Mapping
STS-1 #1 – DS1 Drops
STS-1 #2 – EC-1 #1
STS-1 #3 – EC-1 #2
To Next Page
Loading...
