ADTRAN Total Access 3000 - Page 430

Total Access
®
3000/3010 System Manual
6TADLP744-1E
TOTAL ACCESS 3000/3010
DLP-744
Page 12 of 12
© 2003, ADTRAN, Inc.
Perform Steps Below in the Order Listed
 OC-3 MUX/VT1.5 Mapping – M13 1-to-1 Mapping
 Provision STS-1 L2 MUX
 STS-1 MUX/Provisioning/Linked Provisioning – Enabled (for redundant
operation)
 STS-1 MUX/Provisioning/Clock Source – Receive STS-1 Loop
 STS-1 MUX/Provisioning/DCC Mode – Disabled
 STS-1 MUX/VT1.5 Mapping – M13 1-to-1 Mapping
 Repeat for second Expansion Shelf
 Place Equipment In Service
 Intelligent NE (Client) Shelf
 OC-3 MUX/Provisioning/MUX Provisioning/MUX Service State – In
Service
 OC-3 MUX/Provisioning/EC-1 #1 Provisioning/Service State – In Service
 OC-3 MUX/Provisioning/EC-1 #2 Provisioning/Service State – In Service
 Repeat for OC-3 MUX B (if redundant configuration)
 Expansion Shelf #1
 STS-1 MUX A/Provisioning/Service State – In Service
 Repeat for STS-1 MUX B (if redundant configuration)
 Expansion Shelf #2
 STS-1 MUX A/Provisioning/Service State – In Service
 Repeat for STS-1 MUX B (if redundant configuration)