46
Measure connecting rod small end ID. Replace
crankshaft if out-of round.
Measure piston ring to groove clearance by
placing the ring in the ring land and measuring
with a thickness gauge. Replace piston and rings
if ring-to-groove clearance exceeds service
limits.
6.5 PISTON INSTALLATION
CAUTION: Do not re-use circlips. Circlips
become deformed during the removal process.
Do not compress the new clip more than
necessary to prevent loss of radial tension.
Severe engine damage may result if circlips are
re-used or deformed during installation.
To Next Page
Loading...
Need help?
General
