77
Remove the hub (E) from the spindle. Remove
the inner spacer (F), the spacer maybe in the hub
or located on spindle during removal. Inspect the
inner spacer for wear, replace if needed.
Remove the upper and lower ball joint cotter
keys and castle nuts.
Lift up on the upper A-arm and pull the top ball
joint from the steering spindle. Push down on
the lower A-arm to move the lower ball joint
from the steering spindle.
Tie-rod inspection
To check for play in the tie rod end, grasp the
steering tie rod, pull in all directions feeling for
movement.
Repeat inspection for inner tie rod end (on
steering post).
Replace any worn steering components.
Steering should move freely through entire
range of travel without binding.
To Next Page
Loading...
Need help?
General
