69
Install caliper on the steering knuckle, and
torque mounting bolts. (If previously removed.)
Use an Allen wrench or socket to torque the
front caliper bolts to 33 ft. lbs. (45 Nm).
Slowly pump the brake lever until pressure has
been built up. Maintain at least 1/2” (12.7 mm)
of brake fluid in the reservoir to prevent air
from entering the brake system.
Be sure fluid level in reservoir is between MIN
and MAX lines and install reservoir cap.
Install wheels and torque wheel nuts.
BRAKE BURNISHING: It is recommended
that a burnishing procedure be performed after
installation of new brake pads to extend service
life and reduce noise. Start machine and slowly
increase speed to 30 mph. Gradually apply
brakes to stop machine. Repeat this procedure
10 times, allowing brakes to cool sufficiently
after each run.
To Next Page
Loading...
Need help?
General
