Agilent Technologies 1260 Infinity G1315D User Manual

268 Agilent 1260 Infinity DAD and MWD User Manual
13 LAN Configuration
Initialization mode selection
Since the default IP address is a so-called local address, it will not be routed by
any network device. Thus, the PC and the module must reside in the same
subnet.
The user may open a Telnet session using the default IP address and change
the parameters stored in the non-volatile memory of the module. He may then
close the session, select the initialization mode Using Stored, power-on again
and establish the TCP/IP connection using the new parameters.
When the module is wired to the PC directly (e.g. using a cross-over cable or a
local hub), separated from the local area network, the user may simply keep
the default parameters to establish the TCP/IP connection.
NOTE
In the Using Default mode, the parameters stored in the memory of the module are not
cleared automatically. If not changed by the user, they are still available, when switching
back to the mode Using Stored.

Agilent Technologies 1260 Infinity G1315D Specifications

General

Brand	Agilent Technologies
Model	1260 Infinity G1315D
Category	Laboratory Equipment
Language	English