1b-52
Operation Reference
Function
4. Register Recall Arrows
Press ⇑ or ⇓ to recall the operating settings saved in the registers in the currently selected
sequence. The number of the last register accessed appears in the REG field.
If two dashes (- -) appear in the REG field, a sequence that has no registers saved in it has
been selected.
After the last register in the sequence has been recalled, the register count will begin
again at the first register saved in the sequence.
(Refer to “MEMORY” in this section for further information about register sequences.)
To Next Page
Loading...
Need help?
General
