7-36
Adjustments
Agilent Service Support Software
Agilent Service Support Software
The service support software contains the program and supporting files necessary to run
the automated performance tests and adjustments for your signal generator. This section
lists the equipment required to run the software, and gives instructions for installing and
using the software. Refer to the previous section for a description of each automated
adjustment and refer to Chapter 8 for a description of each automated performance test.
The part number for the service support software is listed in Table 6-1 and Table 6-2.
Required Test Equipment
The following equipment is required to run the software:
• Personal Computer (PC) with the following specifications:
— 386/33 MHz CPU or better
— At least 8 Mbytes of RAM
— Hard drive with at least 350 Mbytes free
— 16-color VGA monitor or better
— 3.5-inch disk drive
• MS Windows version 3.x or mS windows 95, 98, or NT
• 2 Button mouse (optional)
• Printer, MS Windows-supported (for test results documentation)
• 82341C GPIB Interface Card
• 16-bit HP SICL libraries (installed and configured)
CAUTION Do not install this software program on your computer if the ESG Series
Support Software, Version A.02.02 or earlier, is installed on it.
To Next Page
Loading...
Need help?
General
