1a-1
1a Operation Examples
This section contains operating examples to help you learn how to operate the signal
generator. These examples can be performed without any additional equipment. The pager
testing example can only be performed if Option 1EP is present.
If this is the first time you have operated this instrument, perform each of the following
examples for a quick introduction to general operation. After you have completed the
examples, try operating the instrument’s remaining functions on your own. If you have
trouble or want additional information on a function, refer to Chapter 1b, “Operation
Reference.” If a message is displayed that you do not understand, refer to Chapter 1c,
“Operation Messages.”
The item numbers of the following operation examples correspond to the numbers called
out on drawing of the instrument front panel.
1. Setting the RF Output Signal
2. Incrementing or Decrementing the RF Output Signal
3. Using the Memory Registers
4. Offsetting the RF Output from a Reference
5. Holding the Output Attenuator Range
6. Setting a User Selectable Modulated Frequency and Waveform (Option 1E2 or 1EP
Only)
7. Signaling a Numeric-Type FLEX Pager (Option 1EP Only)
To Next Page
Loading...
