XVI U1731C/U1732C/U1733C User’s Guide
measurements 60
Figure 3-5 Changing the power-on secondary parameter and
measurement mode for resistance (R)
measurements 61
Figure 3-6 Changing the power-on open/short CAL 62
Figure 3-7 Changing the Ai function’s phase angle condition 64
Figure 3-8 Changing the power-on limit and category set 65
Figure 3-9 Changing the user high/low limit values 67
Figure 3-10 Changing the baud rate 68
Figure 3-11 Changing the parity check 69
Figure 3-12 Changing the data bits 70
Figure 3-13 Changing the beep frequency 71
Figure 3-14 Locking the push buttons 72
Figure 3-15 Changing the auto power-off and backlight
time-outs 73
Figure 3-16 Resetting the Setup items 74
Figure 4-1 U1782B SMD tweezers 87
To Next Page
Loading...
