ANET3910-EN User’s Manual
<PASSWORD>: must match with the Password configured on the ANET side
Note:
Alternatively the entire sequence described above can be called by a single
command from the standard command prompt by simply preceding the ‘netsh
wlan’ command sequence:
> netsh wlan set hostednetwork mode=allow \
ssid=<NETWORK_NAME> key=<YOUR_PASSW>
The hosted network will use WPA2 encryption per default.
See the displayed settings, after the call of a ‘show hostednetwork’ command
(see below at para 6).
5. start the hosted network via the following input at the ‘netsh wlan>’ prompt:
> start hostednetwork or
> netsh wlan start hostednetwork (from standard cmd prompt)
6. The hosted network can be checked via the following input at the ‘netsh wlan>’
prompt:
> show hostednetwork or
> netsh wlan show hostednetwork (from standard cmd prompt)
7. (Optional) In case the hosted network shall be explicitly disabled, following
command
> stop hostednetwork or
> netsh wlan stop hostednetwork (from standard cmd prompt)
Note:
The ‘start hostednetwork’ command has to be applied every time after a new system
boot or startup. Therefore the command could be added to a batch command file which
has to be executed with Administrator rights!
3.1.4.4 Configure System Services
Click on the Services tab in the navigation bar. You will see now a page where you can
configure the services that shall be running on your ANET3910-EN module and also the
services that are currently running.
The ANS1553 basically offers an ‘endpoint’ or ‘service’ for applications which use the
AIM 3910 ApiConnectToServer” call in order to establish a connection to an ANET3910-
EN. That API function can either use the alias name or the IP address of an ANET3910-
EN.
Note:
If the ANS1553 has been switched off, the 3910 API is no more able to connect to the
ANET3910-EN !
To Next Page
Loading...
