3.1.6 Booting the device into emergency mode
The ANET3910-EN device offers an ‘Emergency Boot Button’ on the back panel of the
device:
Figure 3-15 Emergency Boot Button
The emergency system can be used to start up the device whenever the normal system
start up does not work. It can be used to reset the device to factory settings or perform
software updates.
Press the emergency button while powering on the device, e.g. with a paper-clip, in
order to boot the ANET3910-EN into the emergency mode. The emergency mode boot
is indicated by a red blinking LED. When booting into the emergency mode, the device
will start up with its default factory settings, e.g. user name, password and IP address.
You are able to connect to the ANET3910-EN device with your web browser now.
3.1.7 How to connect Applications to the ANET3910-EN
The following chapters describe how to connect an ANET3910-EN with PBA.pro or any
customer specific application using the AIM Application Programming Interface Library
(API-Library).
3.1.7.1 Connect to a ANET3910-EN with PBA.pro
Open the “Help\About\Settings” tab in PBA.pro and setup the “servers_ppmil” setting to
the alias name or IP address used for your ANET3910-EN, e.g. “ANET3910-3.local”
(see Figure 3-16 below) and re-start the PBA.pro.
To Next Page
Loading...
Need help?
General
