39
6. Startup & Commissioning
6.1 Pre instruction
6.2
Filter house
Filter house: Make sure to ush the supply line in front of the rst lter before adding the water to our system
If the water isn’t clear, rinse until you have clean water before adding it to the system
Fill out AirtecCare with °dH / PPM, µS level, appearance and smell “raw water supply”
• Close and connect the water supply again to the lterhouse
• Insert lter elements to all lterhouses
• Leave the water supply closed / OFF
Before startup ensure that
you have the following
ready:
AirtecCare service sheet
Tool to messure water temperature
Tool to messure water conductivity µS or PPM
Tool to messure water hardness °dH
Multimeter
Startup in 4 steps 1. From water supply – lter – softener – carbon lter
2. RO system
3. HydroSens - sensors
4. Zone - atomizers
Start with the water line before electricity. Ensure that all electrical boxes is closed and the cover is on before putting water to the system.
201218
To Next Page
Loading...