274
TROUBLESHOOTING
Code No. /
functions
Operational procedure / display contents
60
Engine
running
hours
61
Last
periodical
inspection
time
62
Compres-
sor 1
running
hours
63
Compres-
sor 2
running
hours
Monitor mode
Displays engine running hours (code No. 60) / last periodical inspection time (code No. 61) /
compressor 1 running hours (code No. 62) / compressor 2 running hours (code No. 63) in hours.
When compressor 1 running hours are 17,824 hours
Alternately displayed
→
←
Check mode
Programs forced setting of engine running hours (code No. 60) / last periodical inspection time (code
No. 61) / compressor 1 running hours (code No. 62) / compressor 2 running hours (code No. 63)
by 10 hours. (available up to 50,000 hours)
Example) Method of engine running hours setting
Select command
In the case of change 2,345 → 14,970 hours
Less than 10 hours are dropped
↓
Press [SET] switch
During command setting
Digit of 10,000 hours is flashing
↓
Change the flashing digit data with [UP] or [DOWN] switch.
↓
Press [SET] switch (Flashing digit moves to the right)
Digit of 1,000 hours is flashing
↓
Change the flashing digit data with [UP] or [DOWN] switch. (with digit up/down)
↓
Press [SET] switch (Flashing digit moves to the right)
Digit of 100 hours is flashing
↓
Change the flashing digit data with [UP] or [DOWN] switch. (with digit up/down)
To Next Page
Loading...