50
PERIODIC INSPECTION
8) Engine Coolant Additive Refilling
1. Remove the radiator cap to put the specified amount
of engine coolant additive.
NOTE)
If the engine coolant reaches full level before com-
pleting refilling, drain the engine coolant from the
drain plug on the engine block and refill the remain-
ing engine coolant additive.
Pour the drained engine coolant into the reserve
tank.
9) Engine Coolant Amount Inspection / Refilling
1. Check the engine coolant level in the reserve tank.
2. If the engine coolant level is lower than the reference
line, refill the engine coolant until the engine coolant
level reaches the reference line.
Radiator cap
Drain plug
Specified amount
8 TON 10.1 ~ 11.8 fl oz. (300 ~ 350 cm
3
)
15 TON 15.6 ~ 17.2 fl oz. (460 ~ 510 cm
3
)
For engine coolant additive, be sure to use the AISIN
Coolant product.
Refilling interval Every 3 years (10,000 hours)
Reference line
When refilling engine coolant, be sure to use AISIN
Coolant S.
When refilling engine coolant, be sure to mix with the
following balance 50~60 vol% (coolant: 0.55, water:
0.45).
Refilling interval Every 3 years (10,000 hours)
To Next Page
Loading...
Need help?
General