78
REPLACEMENT OF MAIN COMPONENTS
2) Fix the exhaust air heat exchanger and stay by
tightening 2 nuts.
3) Fix the exhaust air heat exchanger and stay by
tightening 2 bolts.
4) Connect the exhaust hose to the exhaust air heat
exchanger.
5) Mount the exhaust pipe. Tighten it with 2 nuts and
2 bolts.
NOTE)
Replace the gasket before mounting the exhaust
pipe.
The outdoor unit has the deodorizing catalyst
instead of the exhaust pipe if the deodorant kit is
installed.
8. Install each wire harness
1) Connect the 2 wire harnesses to the starter.
2) Connect the connector to the engine speed sensor.
Nuts
Tightening torque 14.8 lb·ft (20.0 N·m)
Bolts
Tightening torque 14.8 lb·ft (20.0 N·m)
Exhaust air heat exchanger
Exhaust hose
Bolts
Nuts
Exhaust pipe
Tightening torque 14.8 lb·ft (20.0 N·m)
Engine speed sensor
Starter
To Next Page
Loading...