139
Use the Preset field to select the effect you want to use in XYFX Mode.
Use the Attack knob to set the length of the attack phase of the envelope, which is triggered when you touch
the XY pad. In other words, this determines how long it takes the effect to fully respond to your touch.
Use the Release knob to set the length of the release phase of the envelope, which is triggered when
you release the XY pad. In other words, this determines how long it takes the effect to fully deactivate
after you stopping touching the XY pad.
Use the Wet/Dry knob to set the blend the original signal (dry) and the effect signal (wet).
The X Axis and Y Axis fields show which parameters are controlled by each axis. This varies depending
on the effect you are using.
To Next Page
Loading...
