240
Track Mute Mode
Track Mute Mode lets you easily mute tracks within a sequence or set
mute groups for each track.
To enter Track Mute Mode, press Menu, and then tap Track Mute.
There are two tabs you can view in this mode: Track Mute or Track Group. Tap each button in the lower-
left corner to select it. See the following Track Mute and Track Group sections to learn about each.
Use the Sequence field at the top of the touchscreen to select a sequence.
The counter indicates the current playhead position.
To adjust the position, tap it, and then use the use the Data Dial or the –/+
buttons.
To switch the time increments, double-tap it. You can view it in Bars, Beats,
and Ticks or in hours (HH), minutes (MM), seconds (SS), and frames (FF).
Time Correct lets you quantize track mutes. This is useful when you want your mutes to line up with a
specific time division. For example, with Time Division set to 1 Bar, your mutes will always align with
the beginning of the measure immediately after you press the pad.
Tap Time Division at the bottom edge of the touchscreen, and select a value from 1/16 to 2 Bars (T
indicates a triplet-based time division).
Tap TC at the bottom edge of the touchscreen to enable or disable the Time Correct feature.
To Next Page
Loading...
