35
To load and edit a bass sound, let’s use the software window instead of MPC Touch:
1. If the Browser panel is not visible on the left side of the window, click the triangle (X) in the lower-left
corner to show it.
2. In the Browser, locate and select a bass sample.
3. Double-click a sample to add it to the project. Keep in mind that the sample isn’t assigned to a pad yet.
Let’s continue to set up the keygroup program:
1. Click the Program Edit icon in the upper-left corner of the window to enter Program Edit Mode.
Alternatively, press Ctrl+2 (Windows) or
+2 (Mac OS X) on your computer.
2. In the Layer section, click the Layer 1 drop-down menu and
select the bass sample you just loaded (you’ll see your drum
samples in this list, as well). Because you’re working with a
keygroup program instead of a drum Program, this sample is
now playable across all pads.
Tip: On your MPC Touch, press the Pad Bank D button to switch to Pad Bank D and press Pad 13.
You should hear the bass sample played back with its original pitch. You can use the other pads to
play your sample chromatically.
To Next Page
Loading...
